9dot Active Power Stations NCore Command Module
NCore - Active Modular Energy System 2400W
Active Power and Control
The processors on board the NCore constantly monitor the operating status and all the voltage, absorption, temperature and battery charge status parameters. The software operates proactively by analyzing the applied loads and intervening to guarantee the maximum operating life for the priority devices.
Hot Swap Modularity
Each module can be added and removed when hot, allowing it to operate continuously while ensuring maximum reliability and safety.
Hi Speed Switch
All the actuators and protection diodes have been replaced with low resistance mosfets, guaranteeing instant switching times, efficiency and minimum heat dissipation.
Dual Processor
NCore is equipped with 2 processors. One is dedicated to monitoring and functioning of the hardware part, the other is used for front-end management. This division makes the system immune from attacks from outside.
The command module allows to monitor the status of the connected modules and to remotely send control commands with SNMP and through WEB interface (maximum 12 modules).
It is fitted with Ethernet interface, however, during the installation and maintenance process, it is not necessary to connect the computer as the integrated Wi-Fi interface can manage the system directly from smartphone or tablet.
The WEB interface of CMD is specifically designed to encourage its usage through mobile devices.
You can monitor in real time both the applied voltage and loading parameters and send on/off/power cycle commands.
Data interpretation is made even easier by the possibility to rename and comment the connected devices.
A simple caption colored in red, green or grey allows the prompt identification of the disabled devices and alarms.